About PEDRO AGUIRRE

PEDRO AGUIRRE · 02-01-2009

Hello: Is there any way to achieve the next config but for ACE Module? CSM_1: probe HTTPS tcp interval 5 failed 10 open 5 port 443 serverfarm REDIR1 nat server no nat client ...

PEDRO AGUIRRE · 11-11-2008

Hello!!Plese help me with this cuestion about CSM connection modes:We have 2 Cat6500 with a CSM inside of each (CSM1 on Cat6500_1 and CSM2 on Cat6500-2)The CSM1 is on bridge mode with Vlan31 for Client side and Vlan131 for Server side.The CSM2 is on ...

PEDRO AGUIRRE · 09-02-2008

Hi!!We will do a software up-grade for a CSS11503. At the moment, we have the ADI version sg0730005. We want to install the ADI version sg0810205.On release notes I've found the following:"Required Minimum Maintenance Release Before Upgrading to Vers...

PEDRO AGUIRRE · 08-06-2008

Hello!We are planning an IOS up-grade for a Cat6500 (SUP720). Installed on chassis, we have a SSL Module with a ssl-proxi service, trustpoint and certs loaded.Is there any risk to loose some or all SSL Module configuration (certs included)?Do you kno...

PEDRO AGUIRRE · 08-05-2008

Hi all!!We have a new Cat6500 Chassis.All Modules: Sup720, Line Cards, and Service Modules aren't new (they don't come with the Chassis).Some days ago, the switch was turned-on, but not in Production yet.The following messages appeared:Jul 27 07:03:2...

PEDRO AGUIRRE · 02-09-2009

Thanks Gilles...We need the same feature like CSM or CSS11500 do.Do you know why this feature was suppressed on ACE?I have found at Forum, a reply from you about the same thing: "Replied by: gdufour - CISCO SYSTEMS, CCIE - Sep 18, 2008, 2:03am PSTI h...

PEDRO AGUIRRE · 02-06-2009

The config that we are using on CSM is exactly like I post at the start of this conversation.As you can see, we are using a vserver for the initial client call in http, after, the call is send to the serverfarm called "REDIR1", on this serverfarm we ...

PEDRO AGUIRRE · 02-06-2009

Hello GillesAt the moment, we don't have an ACE module installed for probe the commands, but in the documentation says that a redirect type rserver & server farm (both) do not accept the "probe" command. It is correct?Could you send me a equivalent c...

PEDRO AGUIRRE · 02-03-2009

Hi GillesThe thing here is that we need the same feature we have in CSM.We can't change the actual operative because it represents several changes, maybe on application too.We need any equivalent config. The most important thing is the ability to sen...

PEDRO AGUIRRE · 11-12-2008

Thanks for your confirmation!!Best regardsPedro

Member Since	‎09-18-2000 08:15 PM
Date Last Visited	‎09-04-2020 12:05 AM
Posts	49

User Statistics

User Activity

CSM to ACE redirect equivalent

Cuestion about CSM on bridge&router mode

CSS ADI up-grade

SSL Module cuestion

Cat6500 error mesage %SYSTEM_CONTROLLER-SP-3-EXCESSIVE_RESET

Re: CSM to ACE redirect equivalent

Re: CSM to ACE redirect equivalent

Re: CSM to ACE redirect equivalent

Re: CSM to ACE redirect equivalent

Re: Cuestion about CSM on bridge&router mode