Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Team ,
I'm trying to exec the below command in router 2811 with Cisco packet tracer v6.0.1 to enable subnet zero but could not it so please advise me.
ip subnet-zero
thanks
Hi Team
I can not exec the below 3 commands in the router 2911 in C.P.Tracer v.6.01
test(config)#cdp timer 90 ^ % Invalid input detected at '^' marker.
test(config)#cdp holdtime 60 ^% Invalid input...
Hi
accepted the ip (60.0.0.1 255.192.0.0) but its not accepting this ip (172.16.10.0/24) for vlan management . it gives bad mask error.
I can not exec this "show run all |i ip " My Tracer put remark on word all.
