Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi - Since I haven't found anything that has been able to paint a good enough picture for me by googling I'm hoping someone can give me a real world example showing the purpose of the pass-through port on the bottom of the 1815w as well as the back. ...
Hi, I just got a 3802 AP that I'm testing ME on at home. The 3802 is running version 8.5.140.0 ME code and works as it should currently.I'm trying to get a 3702i that I recently converted from Automous to LW running 15.2(4)JB with image ap3g2-k9w8-xx...
Hi,
Recently we upgraded our PI to version 3.5. Since then every time I open a finished map I'm presented with the error message "Error 11250. The text style "label_ap_controlled" could not be found in the general configuration." I'm unable to loca...
Hi,
At our organization we have many many 702W AP's installed throughout the campus. The ports they're attached to are trunking and passing the data VLAN we use to support the LAN ports in the AP's as designed.
We've noticed that when a user has an X...
I see it's been a while with no responses but am wondering if you ever got this figured out.. preparing the the possibility to Daisy Chain some 1562's together and am looking for confirmation from someone who's done it. Any help would be appreciated....
Thanks. Now if there is only 1 cable hooked to the PoE port in the back of the WAP and nothing plugged into the pass-through port on the back then what happens when a client plugs into the pass-through switching port on the bottom of the WAP? Does it...
Same here. We're running between an 8510 and 8540 on code 8.0.133.0 and 8.5.135.0 due to about 500 legacy 1242's spread out around the campus. We upgraded to 8.5 because while wiring into the 702's with an Xbox, even though the switch ports were conf...
Thanks for pointing me in the right direction. I went through my TFTP logs and found that the transfer was failing after transferring the version.info file. I pulled that file then ran TFTP update on the ME and all was well after that. Thanks again!
