Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As soon as we enable "net flow-export destination 10.1.1.1 2055" on a C6509/Sup720 the traffic seems to be sent out on all of our trunk interfaces. 10.1.1.0/24 is our management network which is trunked out on all trunk interfaces. The Netflow server...
Hello,Can someone help me to understand the buffer failures we get in our 3750? How do you adjust these buffer settings?The failure increases with about 5/secsupervisor_cpuq_2_pool buffers, 2040 bytes (total 64, permanent 64): 0 in free list (0 m...
Hello,We have a problem when adding a third 2950G to to a cluster with two existing 2950G.When we try to add the new 2950G (clean config) to the existing cluster we get: Switch %ERROR: member unreachable (from the web GUI)?The main 2950G is connected...
I need some help in configuring multiple IP addresses for one user in ACS 3.2 Win (Radius). I want to setup a user so that he gets different IP address depending on which NAS he logs into. Can anyone point me in the right direction?NAS1: VPN3030NAS2:...
HiI want to setup netmeeting from the outside to the inside interface on a PIX 515E 6.1.(4). Our PIX is setup without any NAT. Which ports do i need to open?
Ok, thanks.How can i solve this without opening the entire udp range? I suppose fixup doesn't work from outside to inside. Pass through secondary UDP connections on dynamically assigned ports (1024-65535).
