Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello
In the past I have used the ---command line of controller ---- SHOW ADVANCED 802.11A txpower
to obtain the power levels from my AP and what each DBm /mw they were
I Can do this on every AP I have ever had
1131
1231
1142
2602
3602
2702
...
I have no console access and no mgnt port access... trying to get into a spare box we have ... I turn it on , and I have no access ??? Is there a special or different DB9 cable I need??? Is it possible the console and mgnt ports have been configured ...
Guy -it is FIXED now??? and the case is closed ???if you feel the need to hound someone --->go to the tac engineer that advised me at CISCO if you work at CISCO call--> talk to himI gave you the case# there are screen caps of the output not working...
look if your a CISCO employee go look at case # SR# 684073088 AIR-CT2504-5-K9
I have my answer now and the issue is corrected--by a tac engineer. go look at the notes under the case
the output did not work with the Show advanced 802.11b tx power w...
No the answer is the CODE doesn't work correctly BUGGY and is fixed after 8.5.120 <-- show advanced tx power doesn't work as the code is broken for B/G with this output before 8.5.120 on the 2800 and 3800 APWorks after TAC engineer tested and told...
Dustin any info on what to check , I have an IPS 4270- cant seem to get console access or connect to mgnt port..... I remove the cover and On the lcd I get a two codes that flash 01 then 51 any help thanks cant seem to find anything out th...
