Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We've went through and disabled proxy-arp on all of our server farm vlans to ensure the servers are accurately configured with the correct gateway and mask information. However on one vlan we had a primary subnet and two secondaries with proxy-arp d...
Thank you very much for this information. We are testing this now and reading your post beforehand helps eliminate a lot of guess work. Much appreciated!Lee
Hi Scott,That's right. WPA2 + AES + 802.1x.I had disabled the session timeout as we discussed. Also confirmed AAA override is not enabled (as we now know that can affect the session timeout).I am planning to open a TAC case on this. Just thought I...
I'm seeing a similar issue running the 7.3.101.0 code. However, it's only happening (or being reported) for mac users. And it can go well beyond 30-60 seconds. It can go on indefinitely sometimes until I disconnect and reconnect to the SSID. My S...
I had a case opened and Cisco says it is a non-impacting bug. Here was their response:I was able to find what the error messages mean. It’s a stats payload structure definition mismatch between the legacy AP code(ap_m_v12t) and WLC. It does not seem...
Try logging in via CLI and using the authkey parameter below:NCS/lan# ncs ha ? authkey Update the authentication key for high availability remove Remove high availability configuration status Get the current status for high availabilityI'm no...
