Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I am posting this issue on the Cisco community site, I've also posted it in the J-net discussion forums. I have three Netscreen-25 firewalls on my LAN. Two are configured as a NSRP pair/cluster and the thrid is a standalone firewall. All fire...
Hi All,please can somebody help?I was doing a simple test today with 2 AP's, both AP's are powered by Cisco Power Injectors. I was expecting that my client would simply switch association from one access point to another if I disconnected the etherne...
Hi All,please advise, I am probably not the only one, but I have come to realise that 15.4W provided by switch ports on 3560/3570 catalysts is not sufficient to power up an AP1252-AG dual radio device. I have read the spec and it says that a dual rad...
Hi All, I have updated my post on the juniper forum, so will update this thread too with the same information...Firstly thanks for your replies. I have RSTP enabled on all my switches. These new Cisco C3650 series switches are connected to the exsiti...
Hi,Thanks for reading my post, I've found the command, which shuts down the radio if the ethernet goes down:ap(config)#interface dot11Radio 0ap(config-if)#station-role root fallback shutdownap(config-if)#endap#ap#ap#sh ip inter brieInterface ...
Hi Jerome,Thanks for replyingCan't upgrade to "E" type Cats - too expensive, no point taking the radio out - if I do it is a waste of investment in dual radio AP, so it looks like I will have to buy the Power Injector module.Regards
