Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I hope this is an easy one for all. I have a router on a stick setup going on and I would like to put a firewall into the picture. I have two VLANs - VLAN 2 and VLAN 3. VLAN 2 is in the 192.168.2.x network and trunks back to the router at...
Hello,I'm sure this is a simple answer, but I can't seem to find one that sounds like a positive solution. I have two VLANs set up on a Catalyst 2950 switch: VLAN 1 (192.168.1.x) and VLAN 2 (192.168.2.x). VLAN 2 can ping the router on the 192.168.1.x...
Hello,I received a Catalyst 2950 24 port switch from a friend and am curious about the VLAN capabilities. I have looked online for a while and I am coming across mixed answers. Some say that the 2950 only supports one VLAN interface which is the one ...
I followed this post on experts-exchange and now have connectivity to both PIX interfaces (outside, 192.168.2.2, dmz, 192.168.3.2). However, the server still cannot ping 192.168.3.1 and 192.168.3.2, and nothing anywhere else can ping the server 192.1...
I tried your suggestion, but it just made me unable to ping the eth0 address from the 192.168.1.x network. Everything else is still the same as before.
The server cannot ping the trunk at 192.168.2.1 and it also cannot ping 192.168.3.1. All it can ping is 192.168.3.2 (PIX inside interface address) and 192.168.3.3 (itself).
