About vignal-systems

vignal-systems · 07-29-2015

Hello,We facing strange issue on the following configuration:Master switch SG500 : routing vlans 1 (10.0.1.x/24) & vlan 6 (10.0.6.x/24) ip on vlan1 10.0.1.1 ip on vlan6 10.0.6.1 Default vlan 1 tcam +- 400/1024 used for routing Fw version 1.4.1.3 Memb...

vignal-systems · 10-05-2015

4 weeks later:Changing LAG Load Balance Algorithm from "MAC Address" to "IP/MAC Address" issue not came back (yet).Waiting a couple of month before propose this as an anwser.

vignal-systems · 09-01-2015

Ok,We don't have active support contract to open ticket.We don't see this issue before implement LAG between switchs, but we change also the core swith from SG300 to SG500 in the same time so it is not relevant because it is not the exact same config...

vignal-systems · 09-01-2015

For FW & Boot codeFor SG500 :Firmware Version (Active Image): 1.4.1.3Firmware MD5 Checksum (Active Image): f73388df555545d4ac56b89a208493c9Boot Version: 1.4.0.02Boot MD5 Checksum: accbdaec117726d0e5149babc5b2a0b0For SG300 :Firmware Version (Activ...

vignal-systems · 09-01-2015

Hi,First off all: thanks for reading and reply me.For information, when I post message (29 july) we disconnect / reconnect physicaly LACP ports. Everything return normal until the 26 august when problem reappear. And grow until compagny call me and ...

vignal-systems · 11-12-2014

I reply to my previous post: as I can find on internet SG500X device is 3072 TCAM entries and the Sx500 device is 2048.

Member Since	‎02-24-2011 06:10 AM
Date Last Visited	‎07-18-2018 12:03 AM
Posts	12
Total Helpful Votes Received	15

User Statistics

User Activity

LACP Drop packet after couple of week

4 weeks later:Changing LAG

Ok,We don't have active

For FW & Boot codeFor SG500

Hi,First off all: thanks for

I reply to my previous post: