Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 6509 with SUP2 w/msfc2 at home, I am currently have dsl for internet with static IP addresses. Due to AT&T not wanting to support faster speeds in my area, I have to look at another option. All of these will be dynamic IP addresses, cable, u...
I am looking for an option to do the following.@home (dyanmic IP)create tunnel to datacenter routerrequire authentication for security reasonsdynamically route a /29 or /28 to local network@dcAccept tunnel from remote locationrequire authentication f...
I am trying to setup a 3640 to act as a VPN server. I can connect fine to the 3640 using the standard windows vpn client. However, I am not able to determing the remote gw over the tunnel. I have selected use gateway on remote network on the client s...
We have 4 upstream providers. All but one is sending us full tables and default routes. The last one is send full tables only.I was looking to use a route map to define the next hop vs a static entry.Below is what I was looking at trying, but since i...
I am trying to setup a VPN router using a 3640 with dual FE interfaces. Attached is my config. I can ping and attach to anything on the 192.168.40.0/24 network. All the others I can not even ping from the remote users via VPN. I am using the MS VPN c...
Yes I have. It is not a recognized command.I only have the option to set an IP x.x.x.x or dhcp relay. It appears that it may be a bug in 12.2-18.SXF13 as someone reported on dslreports forum that it works in SXF15.I have issues getting SXF15 or newer...
I can use any of the available interfaces on the switch.I have the following modules installedSUP2-2GE (2 gbic slots)6348 (48x 10/100)6316-GE (16x GE copper)Yes it is running Native IOS only.
I was aware of those options, was just wondering if there were any "better" options.Modules in the 2 locations are basic, nothing fancy..@Home1x 6316-GE-TX2x 6408A1x 6348@DC4-5x 6408A1-2x 6348
We are receiving full routes from Providers 1 and 2. Provider 2 does not send us default routes, where Provider 1 does. Since we want to spread outbound traffic across Provider 1 and 2, we need a default route to them. I am trying to find the safest ...
