Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have setup two different subnet 192.168.1.0 and 192.168.2.0 on the same 'inside' interface. They are unable talking to each other. I can ping from firewall to both subnet. Both side unable talking to each other unless I add route on the both side s...
I have seen some previous posts regarding this matter but the solution is not quite clear. Here is my issue:I have a ASA5510 that has the following configuration:ethernet 0/0 outside security level 0ethernet 0/1 inside security level 100 (192.1...
What connector that needs to connect between Catalyst 3560 SFP and Fiber-optic cable with SC connector? I may have LC or MT-RJ on the Fiber-optic cable.Can I use LC or MT-RJ to connect to SFP?Thanks.
Is it possible using Catalyst 3560 as load balancing? FW > Catalyst 3560 > Web Server. I have never using any switch for the load balancing and have no experience at all for this usage.Can anyone help on this subject?Thanks.
The default gateway for the users on the 192.168.1.0 is the ASA. The G/W is 192.168.1.1static (Inside,Inside) 192.168.2.0 192.168.2.0 netmask 255.255.255.0 route Inside 192.168.2.0 255.255.255.0 192.168.1.254 1
Nope. It doesn't work. Log has enable and show in real time. I was able to ping and shown icmp from the log. RDP from 192.168.1.x to 192.168.2.x shown nothing in the log.
