Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a 4507 with dual sups 6-E. The chassis is configured for SSO. I upgraded from 15.2(2)E5 to 15.2(2)E8 by doing the following:1-Loaded the new IOS in the bootflash & slavebootflash2-Edited the boot system so it's pointing to the new IOS3-Iss...
Hello,
What's the difference between a Reboot and Restart? I have a 5520 running 8.2.170 and from the GUI, on the Commands menu, it has both options.
It also has a Reset to Factory Default which is quite obvious.
Thanks!
We recently had to upgrade our 5520 to 8.2.170.0 from 8.1.131.0To speed up the process, I had pre-downloaded the new image to all APs (a mix of 3502i & 3702i). So we rebooted the controller, and after it completed the boot process, all the 3702 APs j...
Hello,
I have a 3702i that is unable to join a 5520. The WLC is running 8.1.131.0
The access point receives a valid IP address and starts a CAPWAP session with the controller, but eventually times out after several retries. From the AP, I see this in...
I upgraded a pair of switches last night, and I added the following commands, and then saved the config. redundancymain-cpuauto-sync standardThat did not really make a difference. After reloading the standby supervisor, it successfully came online wi...
Hi Reza,I am not doing these steps:Switch(config)# redundancySwitch(config-red)# main-cpuSwitch(config-r-mc)# auto-syn standardSo far I've tried on 3 chassis and even though they are configured for SSO, I get the IOS mismatch log and then it stays in...
