Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. After updating from Prime Infrastructure 2.0 to 2.2, I can't create guest user on our WLC through CPI anymore.I always get the following error message(s):"Error(s): You must correct the following error(s) before proceeding:Error:Could not appl...
Hi there.I'm trying to create a monitoring script for Nagios to monitor the usage of video ports on my MCU 5310 ( software version 4.4 ).I found an exemple of a perl scipt using RPC::XML and it works quiet well except for one thing: I don't get the v...
Hello.After upgrade to new controller version 7.5 on my 5508, I have two access points that won't connect to controller anymore.Before the upgrade, I pre-downloaded the new images to all access points and that worked well.I now connected to one of th...
Hello.Some days ago, I updated our 5508 WLC to software version 7.5.102.0.With that version, it should be possible to have a VLAN mapping specific for a Flexconnect group that is set within Flexconnect Group settings.I did that for all my Flexconnect...
Hello.I got "RX Multicast Queue Full" messages in the log of my 5508 WLC for more than a week now and have problems with client association.The multicast mode on the controller is set to "Unicast".Can anybody tell me what the problem could be?Thanks....
Increased the SNMP timeout to 30 seconds and restarted PI, but no change.BTW, Synchronisation of WLC works fine.I noticed something else: if I change an existing guest user in PI, I get the same error message, but after that, its credentials are chan...
Hi Patrick.Thank you for the answer and the investigation.It's not that urgent and we actually think of buying a conductor, so that would be a solution.Maybe I try the feedback thing for now.Regards,Sven Lindeke
Hi.@Martin: It's the same on main status page: no video load. Only under Status->Conferences, I can see the "Video ports in use"@Patrick: Thanks for investigating.Regards,Sven
Hi.The software version of my 5310 is 4.4(3.54)Even the "device.status" call has no videoLoad included.The software was updated two months ago, but I didn't try that before.Regards,Sven
Hi.Ok, I tried everything from the posts you mentioned and nothing worked.I will open a TAC case, but I think that the flash memory is broken.Anyway, thanks for the hints!
