Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone happen to know where to find information regarding the different hardware (not software) versions for the ASA? Specifically, I currently have an ASA 5505 hardware version 05. What's the difference between that and an ASA 5505 version 09? ...
I have a small environment that I wanted some redundancy in. It consists of two layer 3 switches that are connected with each other and they both connect to an ASA 5505, forming a triangle in logical architecture. EIGRP is running between all of them...
I have an old 3640 that I inadvertently uploaded an IOS image to that will not boot. It keeps reloading to rommon. It's part of a lab that has a 3700 series router with console access via an NM-32A. I was wondering if there's any way to do an xmodem ...
I bought a new ASA 5505 and am having a bit of a problem configuring it in the way I need it.Basic diagram:192.168.1.0 /27 --> ASA --> 3524 switch --> 3725 (router on a stick) --> 3524 --> 192.168.2.0 /27I have a 192.168.1.0 /27 network that I'm atte...
Removing/modifying the inbound ACL on the VTY lines of the device I was attempting to SSH from fixed this. Something causes the inbound ACL to actually function in both the inbound and outbound directions.
Confirmed. 9.1(3) does the same thing. The split-horizon command shows in the startup config, but will not be loaded into the running config upon reload. I made sure to load 9.1(3), manually add the command onto the SVI, write the config and then rel...
Not to resurrect a dead thread, but we're having this same issue on several 6500's. We keep getting:%MCAST-SP-4-MET_THRESHOLD_EXCEEDED: Multicast Expansion table has exceeded 98% of its capacity and is reaching its maximumWe have CEF enabled, PIM in ...
