Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am hoping someone can first inform me if this is even possible and second provide guidance as to how I would go about setting it up in the ME switch.I have a sanario where there are 3 locations. Each location endpoint is tagging packets for vlan 10...
Have you thought about using OSPF with the gateway router using "default- information originate" to hand out a default route. Then use a floating static route like you currently have but with a higher metric of 250. If the connection goes down the OS...
Put the DSL modem in bridging mode and then try the following config on your Cisco 877. Let me know it it works out.!interface ATM0 no ip address shutdown!interface FastEthernet0!interface FastEthernet1!interface FastEthernet2!interface FastEthernet...
Sorry but it looks like the adsl port is bad. If the router has advanced ip services you could always use the external modem in bridging mode and use a second vlan with one of the 4 switch ports. Sent from Cisco Technical Support iPhone App
