Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Back with more LMS questions. We have 4.2 running (two separate instances - we have more than one network) and I have a config collection job set up. Upon initial discovery, configs were pulled from all devices into the Shadow director as ex...
Hi all,We have a requirement for SNMPv3. I have implemented it on a test switch, and added a device credential set for it. This switch, which was previously discoverable (and it's traps viewable) via SNMPv2 is no longer visible to LMS. I'm had tho...
Hi folks,I create a custom poller, and would like to add it as a portlet. I see that histo and live-graph it allow you to configure custom values, but they don't seem to accomplish what I need. I'd just like a portlet showing the specific output fr...
Hi all,I've just installed LMS 4.2, like it a lot so far. But I'm running into a few problems, and I'm hoping someone out here has a suggestion. In the Fault Monitor, the Device Name column shows the device's IP address rather than the host name. ...
Hi all,I have a 2611XM that I am using as a terminal server for my lab setup. Async is using octal cables. It works great with routers of all different models, but when I connect a switch of any model, it does not work. The connectivity LEDs don't...
Hi Vinod,Thank you, the group config was the problem! LMS is able to discover the test device via SNMPv3 now. Much appreciated!And yes, the LMS/NMS was a typo above, sorry about that.Many thanks,Jen
Thanks for the info. Super frustrating! I went ahead and added everything to DNS, although I admit I haven't been able to see where in LMS I can define our DNS server - just our SMTP server. Is it even necessary to do that?
Hi Jason,I did find a way around it, and weirdly enough it was not at all what I would have expected. What worked for the 3750s was configuring literally nothing on the console. So line con 0 is blank. Here is what is on the terminal server:line 3...
