Hello,I need to implement the NAT outside command:I configure it in this way:nat (outside,inside) 10.1.1.1 192.168.1.1 255.255...where 10.1.1.1 is the address translated inside of the ousider address 192.168.1.1, so it is able to initiate a communica...
Hello,I need to implement the NAT outside command:I configure it in this way:nat (outside,inside) 10.1.1.1 192.168.1.1 255.255...where 10.1.1.1 is the address translated inside of the ousider address 192.168.1.1, so it is able to initiate a communica...
Hello,I need to implement the NAT outside command:I configure it in this way:static (outside,inside) 10.1.1.1 192.168.1.1 255.255...where 10.1.1.1 is the address translated inside of the ousider address 192.168.1.1, so it is able to initiate a commun...
Hello,I need to implement the NAT outside command:I configure it in this way:nat (outside,inside) 10.1.1.1 192.168.1.1 255.255...where 10.1.1.1 is the address translated inside of the ousider address 192.168.1.1, so it is able to initiate a communica...
Hi all,I make a VPN from a client to a PIX 525 with 3 interfaces (3 LAN: 192.168.1.0, 192.168.2.0, 192.168.3.0) from LAN 192.168.1.0 and receive an address 10.1.1.x from pool: how can I access in secure mode to 192.168.2.0 and 192.168.3.0, and be...
To permit communication SPOKE1 to SPOKE2, you need to add this nat statement on the HUB:nat (any,outside) source static SPOKE1-NETWORKS SPOKE1-NETWORKS destination static SPOKE2-NETWORKS SPOKE2-NETWORKS no-proxy-arp route-lookup
already read: I have done like this document explain but it doesn't function.when I run the show xlate command, there isn't the corrispondent entryThanks for any suggestion!Lorenzo
