Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello together,want to configure two tunnels over the internet, I just want to get more input, how to solve the problem, that when a tunnel fails, that the traffic will be shifted over to the other tunnel.Now the problem is, that the loopback is reac...
Hello,does anyone know a easy way to show the currrent PPP authentication protocol that is used ?I just found on how to get it from the debug output.But if there is an existing connection, how can I make the router show the protocol that is currently...
Hello,how is it possible to RESTRICT the SNMP READ compunity in a way, that using SNMP it will be NOT possible to retrive the configuration file or parts of the configuration of the switch.In my case, there will be a network scan. I have to make sure...
Hello,we are running an ASA firewallsystem and gettingTeardown TCP connection 56410XXX for outside:XX.XX.XX.XX/1521 to inside_demo003:XX.XX.XX.XX/1199 duration 0:00:00 bytes 3334 Flow closed by inspectionAnyone can tell me, the"closed by inspection...
Hello,we are running a cluster pair of two 5540 with on primary and one pecondary.Now we maxed out our licenses for the first time and we aquired more context licenses from cisco.Will the implementation of the new licenses cause an interruption of th...
Hi Lei Tian,than you for your answer.The reason for this tracking is to ensure, that the tunnel is working.Tracking a physical interface does not work at all.Chances that something along the way is not working is much more propable.The tunnel endpoin...
Hello Jeremy,"From what you've posted It sounds like you have a single router with two tunnels of which you want to have one tunnel be primary and the other be secondary. You want to forward traffic over the primary link only until it fails and th...
Hi Smitesh,thank you for your answer.In my case, I have chap and pap configured at the same time. Then after the connection is established, I am able to check the router.In my config I have configured both methods.
Hi Marcel,so it looks like, there is no seperate command to see this.Because I have sometimes to configure it for chap and pap and then if chap is working ok, I would like to turn the support for pap off.Sometimes it is not possible to get the info f...
Hello,how to find the8.0(4.43) ^^^^ number behind a version ?When I go to the software download page of cisco i just get offered8.0.4 ED without any of the .43 number shown.How to find out, what release cisco lets you download under 8.0.4 ED ?...
