Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,You just need few commands to do this...Cisco1750#config tCisco1750(config)#no ip dhcp pool azariahCisco1750(config)#endCisco1750#wr... and you're done.Regards,Chris
Hi Andrew,If you ask BT to do a remote loopback on their CSU/DSU, you should see a "Serial0/0 is up, line protocol is up (looped)" from your main router serial interface.This way, BT can prove to you that their leased circuit is working. If you don't...
Hi Andrew,You've done back-to-back testing on the routers, you've changed it to routing mode and can't ping the remote router serial IP address, it's definitely the BT link that is not working. You can ask them to do a remote loopback on their CSU/DS...
Hi Andrew,From the looks of the config and the 'show int', everything is ok, unless, the remote router has some missing config, such as the 'bridge 1 protocol ieee' or maybe missing 'bridge group 1' on the interfaces.Would you consider changing the c...
Hi Andrew,Can you post the router config to have a better view of the setup? It will help also if you can post a 'show int s0' here to see the status of the serial interfaces.By the way, is it your requirement to do bridging between the 2 locations?C...
