Loading ISO via virtual media and boot option...after a short period of time it stops. „...Unable to start syslog daemon.failedI can‘t recover from this.“ Anyone has seen this? Any idea? Best Regards,Christian
Hey,workflow with ssh task to configure Extreme switch was working fine before UCS D 6.5After this upgrade ( I believe from 5.x -> 6.5) UCS D seem to change Double quotation mark into Single quotation mark (as input variable and inside ssh task) and ...
Hello,I use (non mandatory) Input to calculate values within Cloupia Script task and want to use this Inputs in next tasks:When the next task is e.g. ssh Input variables still have correct values.When the next task is a compound workflows variables a...
I installed SP9 oder SP8 and now both are active:
Node 0/RSP0/CPU0 [RP] [SDR: Owner] Boot Device: disk0: Boot Image: /disk0/asr9k-os-mbi-5.1.3.sp9-1.0.0/0x100305/mbiasr9k-rsp3.vm Active Packages: disk0:asr9k-k9sec-px-5.1.3 disk0:asr9k-bng-px-5.1.3...
I believe it's not related to ssh task itself.I defined a new input variable for testing and even in the first printout (on some kind of calculation cloupiascript task) it has already changed into single (before ssh task).from Log:Workflow Inputs: A...
not sure if I understand correctly. 5.1.3 and SP8 were two upgrades:
Since the TAC case is still open, I will wait for the feedback from TAC.
I decided to clean up the installation and removed that packages:
disk0:asr9k-9000v-nV-supp-5.1.3.sp8-1.0.0 Package to remove
disk0:asr9k-service-supp-5.1.3.sp8-1.0.0 Package to remove
disk0:iosxr-mcast-5.1.3.sp8-1.0.0 Package to remo...