Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I´m a bit confused regarding Jumbo frames on Cat6500.when a jumbo frame enetrs the switch andhas to go out an 100MBit-Interface with Jumbo disabled (MTU1500) -->it´s getting dropped by the switch ??has to go out an Gigabit-Interface with Jumbo disabl...
hello,we have several 7921 voip-over-wireless phones and see this problem: the phone uses dscp 24 (CS3) for signalling traffic. nevertheless when this frame arrives at the access-point and is tunneled through capwap the dscp-value of the capwap-packe...
we want to configure our WLC´s only through WCS. as i saw in the configuration it is only possible to do a manual "save config to flash". this means that we loose the configuration on our controllers when a controller is rebooted in an uncontrolled w...
hi,i have the following problem: i have set a lwapp-ap to factory default via the GUI but used the feature "except static IP". now the access-point is up but can not join a controller because it doesn't have a controller IP. the controller is not in ...
hi, thanks for your response. the problem is: how can i reboot the access-point from remote? currently i can't see a command in the CLI where i can reboot it....
