Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am completely new to EEM and I am in need due to a problem we are having with our cloub web gateway services. While they work out their issues, I need an IP SLA that does a simple http connect and it it fails, reset an IPSEC tunnel. I have the IP...
we need to enable uRPF on a Cisco ASA 5585x but looking at the documentation I cannot determine if it runs in loose or strict mode. for IOS devices, there is the option allow-default that indicates loose mode. our ASAs have only a default route to ...
we have an objective to get 802.1x working with our phones but while we fight that nightmare, we chose to put VACLs to lock down the voice side. we use voice vlans which to my understanding uses CDP/LLDP for the COA or vlan jump. since a spoofed de...
we resolved the issue. we had to add this at the global level for it to run. it is working great now thanks.
event manager session cli username "xxxxxxx" privilege 15
yes. it has been validated. the IP SLA is up and running on 240 routers right now. that is not the issue. the issue is EEM firing when it changes from an OK status to a failure. my problem is the EEM either detecting the down state or executing ...
