Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I planning to integrate cisco asa5505 device in runing enviornment for filter ip traffic.Internet ----router----ciscoasa----lanIp series is public(25.263.25.0/24) througout of network (no privateIP)now how do I set asa in such case and filter traffic...
Hi, I want to connect my both 3560 switch togather.1stswitch:3 vlans but all server are attached to only one vlan8(ip 192.168.5.1/272ndswitch:3 Vlans but server are conneted to one vlan8(192.168.4.1/32only 1st switch is connected to internet:Requirem...
Hi, I have a switch 3560 ios, issue is under vlan2 two server are connected with diff. series network say on port 1 -192.168.5.2 n port 2 192.168.4.6 I want both server can access each other. what should I do ?
Hi, I have two 3560 switches. I need to combine both switch together.I have created vlan8 on both switches with selected ports for my servers.Q1. Do I need to configure any trunking protocol on both side ports to connect both switch ? since I am not ...
jen,I didn;t configure firewall yet and no idea how do I configure it either in transparent mode or routed mode?I need some input on firewall config in such condition where all ips are same subnet.
Jon,You mean I do not need to use any trunk command on both switch ports I just attach them with a cross cable n put those ip using routing enabled on both interfaces as directed by you.. is that right all ?Tell, finally i goona go this now..
Good Jon,one question Do I need to connect both switch phycially first for your solution to work like switch1--gi01---cross cable---gi01--switch2 ?pls guide
