Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After upgrading an RV042 from 1.3.12.19 to 1.3.13.02, it loses connectivity after several hours.RV042 WAN1 is connected to cable modem (WAN2/DMZ is unused), configured to obtain IP Address.Cold booting all devices, RV042, AP & Cable modem, re-establi...
While looking through 4500 IOS installation/config-guides/reference-guides I thought I saw a method to configure a switchport to become disabled due to excessive input/output errors. Is there such a capability/feature?
I have a WS-C3750G-12S that for the foreseeable future will be used as a standalone switch . Is there a way to reduce or eliminate stack election time to speed up the boot process?jph
The log is from v1.3.13.02. The router is passing traffic with no problems since ntp updated the internal clock. Looking at the log, the dhcp process renew and expire times were in the past probably confusing the process. As soon as ntp updated the c...
Jasbryan,Please review attached log file (pdf). I checked @ 10 hours after I manually 'renewed' the IP address from the summary page early this morning. This afternoon, the RV042 was on-line and connectivity was normal, not off-line as I thought it m...
Tom,Another document for consideration is one titled "Clarifying Optical Parameters, Power Budgets, and Fiber Plant Requirements for 10GBASE-E and 10GBASE-L".http://www.cisco.com/en/US/prod/collateral/modules/ps5455/ps6574/prod_white_paper0900aecd803...
As you can see by my other reply, the stp bpdu guard did it's job when the customer switches bdpdu's arrived on the interface.I reviewed errdisable and I understand it takes effect by default for other features when enabled (bdduguard, link-flap, sec...
