Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Expert,Just want to ask what list of codes or IOS the proxy-arp is disable by default? And also how i can confirm that proxy-arp is disable by default?Becasue i noticed some IOS the proxy-arp is disable by default but some are enable by default.I ...
Hi Expert,I have a requirement to connect two 3750 switch with 10G speed between two sites with 150km distance. We will lay-out our own fiber (48 core) between two sites. I just want to consult the following:1. Could i use two core switch 6500 with s...
Thanks for the big help Alexey, i would rather check the IOS documentation of my all devices and verify the default configuration.Thanks again for your time on this.Cheers!Michael
Hi Alexey,Thanks for the link, link says Cisco IOS IP Configuration Guide, Release 12.2 For IOS http://www.cisco.com/en/US/docs/ios/12_2/ip/configuration/guide/1cfipadr.html#wp1001233it looks this is only for the IOS Release 12.2 is it applicable...
I have a test switch which i a deleted all configuration (vlan.dat and config.text). It looks the command only applicable on certain IOS.Test_Switch#sh run all ^% Invalid input detected at '^' marker.Test_Switch#sh run all | i proxy...
Hi Alexey,Thanks for the response. I ran the command show ip inter | i Proxy. Some interface are disabled and some are enabled. So we could not tell which is the one is the default. core2_ash#sho ip int | i Proxy Proxy ARP is enabled Local Proxy AR...
Hello Jef,Thanks for the reply.However the required distance is 150km. I did some reserch and i found the solution to my requirement to reach 150km distance between two 3750 switch is Via ONS or via SDH. See below.1. Via SDH3750 switch > ASR > SD...
