Member since ‎01-24-2012

User Statistics

  • 18 Posts
  • 0 Solutions
  • 2 Helpful votes Given
  • 0 Helpful votes Received

User Activity

                   Hi,I have the current setupUCS chassis (4 uplinks) --> FI --> (Port channel) --> N5K --> (port channel) --> VSS 6500I configure port channel between IO Module and the FI by changing to policy to "Port Channel" and set the link to 4...
Hi,I have the following scenario, Cisco UCS chassis with 2 Blade B440 placed in slot 5 and 7.The blade in slot 5 is taking some time but the VIFs get pinned (FI Uplink) after approx 3 for the server in slot 7 the VIFs using the adapter 2 remai...
                   Hi,I have to install 2 VSM on two baldes B440 (Full-width) and I need the VMs traffic on these blades to be controlled by the N1K.since cisco recommends not to have the VSM and VEM on the same blade.I thought of creating 2 addition...
Hi,I am new to nexus 1000V, the setup is as follows, UCS Chassis with 4 Full width blades connected to 2 FI 6248UP.each FI has uplink to a n5k (no VPC).is there any template for configuring the nexus 1000v? how to configure the port-channel?thanks.
Hi,Is there a way to fake the WWPN of the Storage for the host?the situation is as follows: I have migrated a LUN from an old Storage to a new SAN Storage.Zones and LUN masking are correct and the Host is able to reach the new LUNs.I am receiving  an...
Community Statistics
Member Since ‎01-24-2012 10:33 AM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 18
Helpful Votes Given To