Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I'm struggeling on a very strange phenomen.
One customer of mine is using a Cisco WLC 2504 controller (AirOS Version 8.2.100.0) connected to a HP switch (I don't know the type of model).
LAG is configured correctly as per configuration guide...
Hi Folks,
I'm having troubles with a wireless installation root / non root Bridge using autonomous AP.
The issue is that as soon as I enable encryption the connection is gone.
Without encryption everything is working fine.
I've attached the configs -...
Hi Fellows,
I'm searching for a solution to disable the Ethernet broadcast setting on the WLC globally and enable it only on a per access point / Vlan basis.
Is there any way to achieve this? Maybe through FlexConnect?
I was not able to find any rel...
Hi Forum,
I'm dealing at the moment with the implementation of a virtual Wireless LAN controller in one of our customers environment.
Customer is facing several issues and I'm not pretty sure how to solve them - so maybe the supportforum could give ...
Hi,
A customer of us tried to enforce a split ACL on an access point (2702I) running in flexconnect mode / office extend enabled.
Cisco WLC is of type 5508 with software 8.0.100.0 running.
I searched the configuration guide but from my understanding ...
I'm getting a 2504 WLC today in MY office as well as some HP Switches. I have never faced such an issue before and I've many Setups that are working really good without any issues.
I will try to re-create the issue by today and will post MY results l...
Customer did what I told him to do -> to put the two APs more apart then 10 cms (0,328 feet).
Now Setup is working.
Keyword: Fresnel Zone
I was sure the config was correct as I did not found any mistake in it (Setup was working in my lab too).
ok then the vWLC part is correct - I need to check further on the VMWare part (but I do not have access to this part as it is under the administrive domain of the customer).
I do not have two management interfaces - just one. APs are also able to re...
So basically I'm assuming right that I can use only one vNIC on the VMWare to use tagging on the data port to make the vWLC work (also for the management VLAN) - is this right?
Lets say I have four vlans -> one for mgmt traffic, three for the dynamic...
