Hi Ismael,In this circunstancies it is better that you open a TAC case. They will be able to get a s...

Hi Ismael,Can you try to perform the following to clear the alarm?Clear SEL logs using "clear bmc ev...

Hi Ameen,WCCP is supported in your current Switch model on IOS XE 3.3.0SG on IP Base or Enterprise S...

Hi Douglas,That is fine, Please perform the steps below:1) log in WAE and issue the "WAE(config)# no...

Hi Douglas,ASR platform will only support MASK assignment. You can use the documentation below for y...

Hi Douglas,What's the router/switch platform you are running ?Could you also send the wccp configura...

Hi Marcelo,You can use the example below, in this case there are 1 inline group in Cisco WAAS, the i...

Hi Joe, Waas Mobile and WAAS are going to be both optimizing traffic in this case. While WAAS mobile...

Hi May,The output of CLI seems to be correct, if this is your first time logging in the WAE device, ...

Hi May,Can you confirm you are connected to the WAE using the serial interface? If you are looking t...

Hi Brad,You cannot use this HW box to install any other OS other than Cisco WAAS, we have the Bios c...

Hi Joseph,Can you send me the output of the following commands please?1.show ip wccp2.show ip wccp i...