Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
good day
i tried to configure 2921, ASR1000-x with OOB using ospf but my routers cant form adjacency please help here are my configs. using ip protocols on 2921 i can see the routed networks however on ASR1k i can only see routed protocols on the vrf...
hi all
i am trying to use this command
router#ping <ip address> repeat 10000 in EIGRP scenario
Router#ping 10.1.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.1.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5...
good day
sh commands from ASR1k-x
sh ip ospf 100 int
GigabitEthernet0 is up, line protocol is up Internet Address 172.25.3.51/27, Area 0, Attached via Network Statement Process ID 100, Router ID 172.25.3.7, Network Type BROADCAST, Cost: 1 Topology-M...
hello Rolf
i changed priorities of both routers but it doesnt help. maybe it could be the router ospf 100 vrf <vrf name> in the ASR1k which is different from the 2921 command "router ospf 100'' the ASR has a management interface only Gigabit ethrtne...
