Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All, I've recently started to configure a NAT'ing policy for a cisco ASA 5515 (using FirePower) and I have run into some seriously odd issues. Here's the basic scope.Physical Config:single upstream (1 Public in a /26) link on ASA rest are downstream...
All, I've been trying to get Port Mirroring working on an ASR 9001 with the following configuration basics monitor-session test destination interface gi0/0/0/8 ethernet (default) But I've run into an issue. All my books and statements say I need an ...
All, I'm in a bit of an odd situation. I had to change over the primary nameif on a Cisco ASA 5510 running 8.2(5) DeviceManager 6.4(5) Currently everything works as intended (natting, vpns, ninjas) except for internal access services including telne...
I'm trying to find a Mac Address in the ASR9k table. We have a server with multiple mac addresses and we need to know what MAC is being learned by what interface. Thank you,
Please NOTE Heavily Obfuscated : All public turned to 10.255. NOTES : All Internet Traffic unless it's in a static NAT should be translated to 10.255.37.60Primary Out Interface uses 10.255.37.61 Here is the configConnected:@ 2015.04.24 - 08:41 - ...
You are correct. It was the Inside Interface. I have kept the "management-access inside " statementAny other suggestions?I should reiterate - I have had that statement since the change-over still no ability to SHH/TELNET/ADSM through the local int...
