trickylalit
Level 1
Level 1
Member since ‎06-14-2016
‎08-18-2017

User Statistics

  • 36 Posts
  • 0 Solutions
  • 25 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Discussion Posts
30 Discussion Posts
20 Discussion Posts
First Discussion
First Question
10 Discussion Posts
1 Reply
20 Replies
10 Replies
5 Replies

User Activity

Hello All, We have a security system with static ip. We can ping fine. However, when we try to connect to application it fails. When testing the tcp port with telnet, connection denied. Every single time when we cannot connect, we get this message i...
  SW1(Main Switch)- SW2-Sw3 It is probably a basic questions but wanted to get clear about. Would it be right to say to say that SW2 has 1 uplink and 1 downlink. SW1 has only 1 downlink and SW 3 has 1 uplink Searching ,mostly article talk about upli...
Could I Display like int gi 1/0/1, 1/0/2...... On Similar lines you can exclude  specific interface when you run the command. Say I want to see all mac addresses in order of interface and exclude the trunk interface. Thank you
%C4K_EBM-4-HOSTFLAPPING: Host 3C:A9:F4:65:89:98 in vlan 1 is moving from port Te1/1/1 to port Po1%C4K_EBM-4-HOSTFLAPPING: STANDBY:Host 3C:A9:F4:65:89:98 in vlan 1 is moving from port Te1/1/1 to port Po1 I see this messages a lot for different device...
for testing , I had Ip routing enabled and had vlans with ip assigned to interfaces. I have removed the vlan but this configuration still is there.  interface Vlan2 no ip address no ip route-cache!interface Vlan3 no ip address no ip route-cache Tha...
Community Statistics
Member Since ‎06-14-2016 08:33 PM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 36
Helpful Votes Given To