Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In the CGR2010 datasheet , there is no any special requirement about ventilation of CGRs.
I want to know is there any special cooling systems or fans mandatory for the operation of CGR?
what would happen if we use CGR2010 without any fan or dedicated...
Hi,
I have a question about using Ethernet Module Switch in CGR2010,
Is the "ESM IP services with Express Setup license " mandatory in a CGR2010 equipped with ESM.
Or the licenses of CGR are enough ?
hello,
In a project we have two CGR 2010 in two substations. I want to connect SFP port (optic) of former to ETH port (copper) of the latter.
Is it possible by use of a commercial media converter such as MOXA or something like this ?
Someone told me ...
Hi,
I have a question about cisco CGR 2010.
is there any module for RS-485 interface in CGR 2010?
Does support CGR 2010 Modbus protocol ?
Someone proposed 4-port and 8-port sync/Async serial GRWICs. but i didn't find anything about RS-485 interfac...
thanks.
Is the Express Setup, a part of IOS ?
if i purchase an IOS (with SG20UK9-15203T SKU code) then i need another license for setup the initial IP for ESM?
Thanks George,
the answer was supportive.
i have another question about CGR 2010.
is there any module for CGR 2010 to add RS-485 interface to system.
i found two GRWIC module , one 8-port and the other 4-port. both of them support sync/Async serial...
