Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 7961 over a DMVPN tunnel and I have factory reset the phone. It now will not upgrade. I'm on a distant site and the call manager can see the MAC addy of the set. My question is this: The tunnel is very unstable, going down multiple times...
I have a NME-16 on a 2811 router with a PoE power supply. When I plug in a 7961 set I dont get any power. The port doesn't even light up to recognize the phone. It will on a laptop but not the phone. CDP is enabled. Any help would be appreciated...
Not sure where to post this so I will try here as well. I am trying to use the password recovery for an NME-16 and am having trouble. I am unable to look at my files in dir to so I can rename them. I can get the switch to bypass the config and com...
I am trying to use the password recovery for an NME-16 and am having trouble. I am unable to look at my files in my dir to so I can rename them. I can get the switch to bypass the config and come with the switch: prompt, but can not do anything mor...
No, I dont have any of those. I'm sure my cable and phone are good because when I plug them into another switch the set comes up with no problems. Is there any documentation on this message Cannot execute cmd on legacy switch 1
The patch cable is good and so is the phone. I've tested both on another switch. I dont think its the wiring due to the Cannot execute cmd on legacy switch 1 error. Not trying to be difficult, but I cant seenm to find any documentation on it.
Here is show power inlineModule Available Used Remaining (Watts) (Watts) (Watts)------ --------- -------- ---------1 n/a n/a n/aInterface Admin Oper Power Device Class M...
