Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have a few new 2702i-B-K9's that I'm unable to get to join my network. I do not see the MAC's from the switch side, nor can I ping the IP I've assigned to int BVI1. My 2702i-A's were not this difficult.
Regards,
Brocade Switch (configured exactly like ports with existing AP's connected)
Tagged to VLAN 2, 200, 201 (10.1.2.0/24) AP is 10.1.2.11 (Same as Cisco Trunk)
Prefer no DHCP on that VLAN
PC can ping DHCP server
I have enabled option 43 with the same results.
I connected a USB NIC to the switchport and to my laptop and gave it a static IP. I am able to pass traffic. If I connect the AP, the switch cannot even see the MAC.
