Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Can someone help me with a design challenge i am facing, and how i can overcome the same. My setup looks like below. I fear if routes will be reflected all the way to R1 and R2
I don't think there should be any issue .Get the basics right, you need connectivity between two routers A and C which are two different offices.. So they will not have any physical connection.. Hence, ensure that you form a routing path, may be GRE,...
This is not the forum where IOS can be shared, please use a search engine to find other sources.Try:http://www.careercert.info/2009/05/new-cisco-ios-version-124-collection.htmlRegardsSreeSent from Cisco Technical Support iPhone App
Hi Mahesh,Your understanding is correct, The behaviour is because of the cost related to Serial interface,Try to use the metric-type keyword during redistribution and you will see different result ( metric-type 1, Default is type 2 ) RegardsSreenath
Hi Mero,Please provide the output of the commands Executed by you ie:show ip ospf databaseshow ip ospf neighshow ip route ospfPlease ensure that there is no MTU Mismatch between the Routers.You may also want to check if OSPF is configured as Point T...
