Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,when I issue R10(config)#do show ip static route 150.1.3.3 255.255.255.255 then it tells me that it has for example 2 static routes and it shows that which on in active and which one is non-active Now my question is that is there any command to...
Hello,
How can I configure IPV6 access-list to allow the OSPFv3 and EIGRP traffic and hello packets so that the neighbor relationship can be established without any problem?
Thank you.
What I want to do here is to generate a default-route on BR4 ( Totally NSSA ) which till this part it is simple
by
BR4(config-router)#area 4 nssa default-information-originate metric-type 1
and advertisement of this default-route reaches the HQ ( ...
Hello guys,
I used named EIGRP for IPv4 and IPv6 , for IPv4 it works good, but with IPv6 named EIGRP after configuring the address-family ipv6 unicast autonomous-system 66 then (it automatically makes neighbor relationship with others without the i...
Hello Guys
I created a simple scenario on a L3 LACP topic and I assigned IPs to both ends and I can do ping from end-to-end but on both of MSWs interfaces are going down and resume to up state and when I turned the debug LACP on I get this messages...
Hi,
I have the same Question, But I think that since you are using the VTP v3 then you cannot just issue the #vtp pruning on the Primary-server-VTP and being able to propagate the pruning state to the other VTP v3 SWs in your VTP-Domain,
and I thin...
Hi ,
Thanks for replying,
Actually I was hoping that I could get an answer to be able to just input 1 permit line on IPv6 ACL to do so
Like what we can do to allow the RIP-NG hello packets to freely establish the neighbor relationship,
like : the lin...
Hello,
I changed the HQ router-id to 222.222.222.222 but still the same situation.
and BR4 gets its default route through the ( neighbor default-originate ) BGP command at its bgp peer
Thanks.
