Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, in tengiga interface (e.g. SFP+ 10GBASE-SR), the nominal throughput of 10 Gbps has to be considered as sum of RX and TX bits or 10 Gbps in RX and 10 Gbps in TX? Considering the following whre RXBS+TXBS = 8.8 Gbps, the interface is near saturation...
Hi,i'm running CiscoWorks LAN Management SolutionVersion 4.0.1.In the netwrok there are several 2821 routers, all running the same IOS : Version 12.4(15)T11, RELEASE SOFTWARE (fc2).The CiscoView Module:for some of these 2821, is not showing vwic2 car...
Hi kubn2, thanks for your reply.The interface is used for a 10 Gbps AWS Direct Connect.We see packet loss as soon as Te0/1/0 throughput reach 9 Gbps (TX+Rx).Platform used is cisco ASR1001-X (1NG), with the following license:asr#show platform hardware...
Hi Gaganjeet,thanks for your interest.The device credential verification is OK for all the devices.For devices affected, only the specific card is not viewable (not coloured).This is OK:This is KO:
