Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI currenly run OSPF between an MX located in our main campus and the Cisco L3 switch which connects the MX to our main LAN. I'm ooking at building a significantly larger Meraki network at a remote site that will use HA MX250 and MS425 as a L3 dist...
HiCan anyone tell me if there is any guide out there that tells me how to interpret the reports that can be generated in Cisco Prime. For example if I run a report on client count per AP, is the result telling me how many different clients connected...
HiAm trying to set up some APs in Flexconnect mode that connect to a WLC runnng 8.3.143.0 that will advertise an 802.1x profile. The RADIUS server (ISE) matches the user against AD and then returns different VLAN values in the Authorisation Profiles...
HiI am looking to advertise a number of wireless profiles for an organisation that has a presence on our campus. I will use our APs to do this and then run Foreign/Anchor set up for each profile so that clients of these profiles break out onto the o...
Hi allHaing recently upgraded an HA pair of 8510 to version 8.3.143.0 I suddenly found that the switches were complaining about Duplex mismatches on ports connected to APs. I did some troubleshooting and googling and came to the conclusion that thes...
Thaks jdsilvaI had found the VPN check box on the static route creation page. What I will probably do because I will be creating a lot of branch subnets is create a single ummary static route and then control access to the VPN using firewall rules....
Hi jdsilvaYes there would be an Auto VPN between the HQ and the Branch and therefore the MXs at either end would automatically share routes. However, what I had wanted to do was only configure the branch subnets on the MS425 and then route traffic to...
Hi JoeyYes i;ve done the mappings. For the AP Mapping I've done this under the Flexconnect tab for the AP, checked VLAN support and mapped the SSID to the VLAN. For the AAA overide I used the VLAN-ACL Mapping mechanism within the Flexconect Group. ...
