Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an odd one. I am trying to connect an MR46 (29.5.1) on new Leviton CAT6A cable plant. All runs tested are less than 150 feet. Problem is I get the AP connected and the switch (MS225 15.21.1) shows power but no data. The AP tries over and over ...
A bit about yourself & your workI have been working for the Los Rios Community College District fro 18 years as a Network Admin/Analyst. I started when the first switched network was installed. Xylan 10Mb half duplex to the desktop with a 10 Mb backb...
I'm the network guy. I have the layer one team come out to test. I can only imagine they are using the correct parameters. I'm not sure. It is a Leviton cable plant from end to end.
We are using standard 568B wiring. We are testing with the same cables used for patching. This is happening in 2 different buildings. We even swapped out the switches. I putting my money on a poorly terminated CAT6A cable. I have not looked at the te...
