Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I am trying to enable multicast mode on standalone AP.
Products are AIR-CAP1702I-Q-K9 and AIR-CAP2702I-Q-K9.
By the way, the reason I would like to use multicast is to use product called "Hearing hotspot".
It is able to import several channel of ...
For the readers.
I personally concluded it 1702 or 2702 multicast does not work with standalone mode.
It seems far beyond difficult to get it work as that way, even if it does.
I tried with WLC controller and turn on simple setting and no problem , ...
Hi
It is not on bridge mode and it should not be bridge mode because of whole designation.
I know it is on standalone mode and I am not quite sure why the command you specified helps the way to setup standalone/multicast.
I will try to read the page...
Thank you for reply.
Can you point out which part of the document tells the standalone mode can use multicast?
I read the document you referred before. However, could not find the part which tells it.
Or specify the config of it?
As I mentioned abov...
By the way, I forgot to mention it did not work.
Also Cisco vendor officially answered me it does not work on standalone mode.
I doubt if it true though.
Thanks for reply
I have tried the "no ip igmp snooping" command as you mentioned.
Even if it worked for some people on the thread you referred.
Probably, it works for 1130 or 1142 series but not on 1702 or 2702 series.
Or maybe some config on L3SW I...
