Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have multiple Cisco FTD 1010 running on ASA image have been facing issue with disk. asa-eureka-ca# dir%Error opening disk0:/ (Input/output error)asa-eureka-ca# fsck disk0:The ASA is operational but wont save any data, or reboot.I have multiple dev...
We have IPSec tunnel between 2 sites.Hub Site: Cisco ASA 5515 Remote Site: Cisco FTD 1010 running on ASA image. We recently upgraded our IPSec tunnel from ikev1 to ikev2. The tunnel was working fine for 2 days and suddenly stopped working.Both the si...
Hello, We have around 150 Cisco ASA 5505 deployed in the field and we are currently in the process of upgrading our infrastructure. Currently, we have an RSA key used for authentication purposes on the ASA. Does Cisco ASA 5505 support using ecdsa key...
Hello, I am trying to setup SNMP v3 on our Catalyst 2960 switches.I got the configuration setup and it`s working. But I noticed SNMP information can be pulled from other NMS if correct credentials are provided. Below is my SNMP config on Catalyst 296...
We recently started with the process of upgrading the firmware on all our Cisco ASA 5505.
A couple of ASA failed to boot up when reloaded. Attached is the screenshot of ASA during boot-up.
The firewall keeps on looping in the NIC initializing state. ...
If I remove the cables, the ASA boots up fine and works as expected.
The problem arises when the power is lost.
The running config is at the default as I cleared up the ASA.
I can attach the running config once I am back to my office.
The ASA previously had version 8.4.3.
I tried upgrading to 8.4.5 & 9.2.4
No change in result.
Even booting with 8.4.3 later kept looping.
The ASA will boot up successfully if all the ethernet cables are removed.
The problem comes when the etherne...
