Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have only seen this problem with several video conferences from one location. Currently there is only one T1 connection from our HQ to remote location. When two conference calls are set to use 256Kbps connection to come back to the main HQ, after...
I have a 2911 and a 1921 router, both are having unknown protocol drops only on the GE 0/0 interface. Both routers are connected to HP switches:2911 -- E5406zl1921 -- HP 2600 seriesI disabled CDP on both routers, but the unknown protocol drops on th...
We will be adding three locations to a MPLS connection. These are remote locations without a lot of traffic and wanted to know if something like the Cisco 1941/K9 would be sufficient? The three sites will be getting 20Mbps connectivity.http://www.n...
I have a Cisco 2911 router with 4 T1 connections. Two are set as a multilink and the other two are for two other locations. The router will run fine, but after a month I cannot ping the gigabit ethernet 0/0 interface. I would have to manually rebo...
Yes it does. Thanks.I also have a 1921 ISR would that be the same as the 1941? The 1921 ISR will be getting a 100Mbps connection to a 2911 ISR. The reason I am asking is because I didn't see the 1921 on the PDF.
