Router Suggestions for Remote Site MPLS

[dudeman893]

We will be adding three locations to a MPLS connection.  These are remote locations without a lot of traffic and wanted to know if something like the Cisco 1941/K9 would be sufficient?  The three sites will be getting 20Mbps connectivity.

http://www.newegg.com/Product/Product.aspx?Item=N82E16833120352&nm_mc=KNC-GoogleAdwords&cm_mmc=KNC-GoogleAdwords-_-pla-_-NA-_-NA

Thanks in advance.

[Marwan ALshawi · Accepted solution]

For about 20M 1941 is more than enough

Refer to the bellow link

http://www.cisco.com/web/partners/downloads/765/tools/quickreference/routerperformance.pdf

Hope this help

If helpful rate

Sent from Cisco Technical Support iPhone App

[dudeman893]

Yes it does.  Thanks.

I also have a 1921 ISR would that be the same as the 1941?  The 1921 ISR will be getting a 100Mbps connection to a 2911 ISR.  The reason I am asking is because I didn't see the 1921 on the PDF.

[Marwan ALshawi]

You can check it's data sheet bout for 20m I would say it won't be a problem Unless you need high level of encryption on top of that in this case you need to be careful

Hope this help

If helpful rate

[Latchum Naidu]

Hi Richard,

Yes, I have 1941 at one of my site in Germany and it handling 30 MB link and another 4 MB internet link.

Please rate the helpfull posts.

Regards,

Naidu.