Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm receiving the following error for igmpv2 traffic:6Dec 30 201112:08:06172.28.9.5225.10.249.12Deny IP from 172.28.9.5 to 225.10.249.12, IP options: "Router Alert"The syslog ID is 106012 and the explanation to correct this makes no sense to me. ...
Hi,ASA 5505 8.2(5), ASDM 6.4(5). I have a segmented network, VLANs separated by SVIs on 6506. Every SVI is configured to use pim sparse mode. The RP is an SVI on the 6506. I attached the inside int of the ASA to a new SVI I created. The outside ...
Hi,I had to move device, when it powered back up, it wouldn't boot. I can set IP, server, etc. in ROMMON and tftp boot. The problem is once I'm in P.E. mode, I can't ping the tftp server so I cannot begin to copy files in flash. This is strange be...
I realize this question is 5 years old but still relevant to me. It appears if you have Linux available with 10Gb interfaces you can install iperf on a receiver and sender device. This is the only way I've ever successfully tested throughput for wi...
You have to use the Win 7 client ending in .0440, you need the Citrix DNE update as well. Follow these steps: https://www.techrepublic.com/article/how-to-enable-the-cisco-vpn-client-on-windows-10/
Use the Win 7 .0440 client. You need the Citrix DNE update as well. Follow these steps: https://www.techrepublic.com/article/how-to-enable-the-cisco-vpn-client-on-windows-10/
