Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All: We have a trouble about the Tacace Authorization was not working on the small part of the 2960 switch ,if I show run int f0/1、show authentication sessions int f0/1 on the Switch of 2960 ,the log display "% Authorization failed.",but the...
HeHe，Yes，It's surprising. this log happened on a few swtich of 2960,and the other device working fine.but I'm sure that it was acs out of the fault.by the way,I'm adopt your suggestings and try again .if the issue solve ,I will be inform you.thanks!c...
Hi Sir: In the acs server ,I can found authorize passd commad only from tacacs administrator,but the failed logs was not in here. thanks!aaa new-model! !aaa authentication login default group tacacs+ localaaa authentication login console localaaa...
Thanks Rick,there are our all devices standard configuration about aaa section, as a result of ACS 4.2 was end of support ，we can't open a case with cisco ,it's very rascally,but I can found some important message from the "ACS→System Configuration→S...
