Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am looking at a large network with multiple areas. However, the network isn't documented very well. Is there any command on the Cisco router to find out all the OSPF areas within this OSPF domain?
Regards,
Deepu.
Hi,I have recently replaced an IDS-4230 sensor with an IDS-4235 sensor. The 4230 had it's monitoring interface plugged to a Cisco FastHub 400, which is a 10/100Mbps hub. If we plug the 4235 to the same port on the hub, we cannot get sensor events. I ...
When I issue this command on our distribution router, I can only see area 0.
We are peering with our service provider using OSPF on a single area (backbone area), area 0. At the remote sites, our WAN links are in area 0 with the same service provide...
Hi,An APP session is used between two CSS switches for maintaining redundancy. The CSS esentially uses VRRP for the redundancy.It is esentially used for box-to-box redundancy.Regards,Deepu.
