Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have run through the quick start guide and have the module up and running but can change the ntp setting from the cli while sessioned into the module. Is it under expert or system modes? On the old IPS I would just run setup again, so is there an o...
For site to site vpn which should i use? I understand the ikev1 is the vpn client and that ikev2 is for anyconnect, but in the world of just basic site to site, which one do you use?Ikev does not seem to have an option for the transform set.Sent from...
Part of my OCD is a need to know where to find cli commands are configured in asdm. Does anyone know where to find the sysopt connection permit-vpn is configured in asdm?Sent from Cisco Technical Support iPad App
Bpdu guard keeps error disabling my trunk ports to the 4260. Two physical interfaces for two inline pairs (inside and an outside) with 2 vlans per trunk.Anyone got any experience with this problem on nexus gear?
I am building 20 pairs of failover firewalls for work and I was wondering from the users of the new code 8.3 - 8.4 if there are anything to watch out for. I know NAT changes from 8.2x to the newer 8.3 - 8.4 lines but would like to hear about real wo...
that did not work. I finally, did it through firesight. the documentation is a lot better. quick start http://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/sfr/firepower-qsg.html firepower http://www.cisco.com/c/en/us/td/docs/security/asa/as...
IPSec support added for AnyConnect Mobile clientASA5550 available contexts upgraded from 50 to 100IKEv2Support for the ASA 5585-XSeperation of the Host Scan package and CSDStateful failover support for Dynamic Routing Protocols!Ether Channels
