About mark l

mark l · 03-12-2017

We are using Cisco Switches, recently planning to roll out Cisco SPA phones. Cisco Switch supports CDP, what Vlan settings do I have to configure on the SPA phones? On the cisco switch we plan to configure vlan 100 for data, vlan 200 for voice. The b...

mark l · 02-27-2017

Hello all, planning to buy few SPA 301 phones, Can you do call transfer on this model? thanks!

mark l · 02-22-2017

Most of the online setup guide describes: vlan10 for data, vlan 20 for voice and there is a default vlan 1. Can I use default vlan 1 for data? so I only have two vlans instead of three.. vlan 1 for data, vlan 20 for voice? Is there a reason we don't...

mark l · 02-16-2017

The switch is configured with access vlan 10 and voice vlan 20. To connect this switch to the firewall (sonicwall), I guess I need to configure fa0/1 as a trunk port, and connect this fa0/1 to the sonicwall's lan port. How should I configure the soni...

mark l · 02-16-2017

Sorry boys and girls, I am new to Cisco, can anyone please explain to me: 1. SW1 is configured with switchport access vlan 10, Switchport voice vlan 20 on port say.. fa0/2. if I connect an IP phone to Fa0/2 and PC attach to the switch port on the IP...

mark l · 03-14-2017

switchport mode access switchport voice vlan 200 switchport access vlan 100

mark l · 03-13-2017

I will configure the switch as 'recommended practice', in this case, on the SPA phones, do I have to alter these default settings? Enable VLAN: No VLAN ID: 1 Enable PC Port VLAN Tagging: NO PC Port VLAN ID: 1

mark l · 02-28-2017

I am using a hosted PBX, so no issue on the 'transfer' feature. On Cisco website, the datasheet says Cisco SPA301 supports call transfer. http://www.cisco.com/c/en/us/products/collateral/collaboration-endpoints/small-business-spa300-series-ip-phones/...

mark l · 02-16-2017

Thank you Francesco, "If you connect a switch to that port, all machine connected to that 2nd switch (with default vlan 1 config) will go through this switch-to-switch link and get vlan 10 as their data vlan." I have tried to connect an IP phone to...

mark l · 02-16-2017

Thank you Richard, 2) If you have configured the switch with a management address of 192.168.1.1 and the PC has an IP address of 192.168.10.2 then the PC will not be able to communicate directly with the management interface of the switch. When you ...

Member Since	‎02-16-2017 04:13 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	10

User Statistics

User Activity

Cisco SPA and Cisco switch

Call transfer on Cisco SPA 301 IP Phone

Can you use default vlan 1 for data vlan?

Switch trunk port to sonicwall

Native Vlan1, data vlan, voice Vlan

switchport mode access

I will configure the switch

I am using a hosted PBX, so

Thank you Francesco,

2) If you have configured the