Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The last cisco APs I setup were I believe the 1240 series and with those I would just go into to the cli, give the device an IP Address, add it to a network switch and then proceed to modify it through the web interface.
I just bought 2 air-ap1852i-...
I am looking to allow my Cisco 891f the ability of being able to hit internal IP addresses using the Public IP Address. With my previous router I could use the public IP Address from the LAN and WAN when trying to connect to computers with external p...
The firmware corrected the issue instantly. I have 2 APs and I would make one a controller and the other would not connect, and vise versa. One AP had a really old firmware image and the other was running 8.3.102.0. Richard pointed out that firmware ...
Yes correct 8.3.102.0. I also bought the contract for the updates, but still waiting on the #, the serial # alone are not letting me register them with Cisco currently. That is why when you mentioned that the controller may be the wrong image I thoug...
I factory restored it when I swapped their positions so it is dynamic currently.
264[*04/04/2017 21:54:22.0799] Join Response from 192.5.100.245[*04/04/2017 21:54:22.0799] TLV-DEC-PROC: Info missing for 1363[*04/04/2017 21:54:22.0799] CAPWAP State: I...
I reversed them. Still not joining but here is the sysinfo for the current controller. This one doesn't have the same line item, but I suppose just reflashing the image anyway is the way to go?
Controllers configured in the Mobility Group MAC Addres...
