Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We have a Site A with Palo Alto (PAN) Firewall and Site B with Cisco ASA 5510. IPsec tunnel is built between these 2 sites.
In certain occasions, we have ISP B network up, but the users are experiencing no internet in Site B. As it is only a si...
Hi
I have a SG500-24 port switch.
To use this switch, i need to set system mode to L2 . Currently, it is showing as L3 mode.
Logging into the switch, I noticed that the GUI is grey out for the set mode L2 or L3. Currently, the radio button is on L3....
Hi,
I have an existing site with Cisco ASA IPsec tunnel to my HQ Site with Palo Alto firewall. Users at the existing site obtained their IP address via DHCP Server configured on the ASA.T he inside interface is G0/0 with 10.10.1.10/24 and outside int...
Hi Richard
From the above :
"I agree with you that there will be 2 tunnels during transition. One to the old site, and the other to the new site."
If i am using 2 different tunnel at the HQ Palo Alto firewall. In the new office, can i use the same...
Hi Richard,
Thanks alot for your help and good advise.
i agree if one site is doing nat exemption and the other side not doing nat exemption, this should be ok.
I guess that i will choose option 2 where each site will have a totally different sub...
